My Summer Car – How To Do The Wiring Mess Step By Step?

My Summer Car is a pretty useful game in terms of teaching us where the part goes and how lethal any given part can be. However, if you do not have any prior experience of the game then this can become quite hectic as finishing the car is itself a huge job that can take a lot of time in-game.

Once you have finished assembling, you will then realize that it is still incomplete as there is a Wiring Mess on the shelf. After nodding your head, the only task you will have is to connect the wire to the specific parts safely unless you wish to get electrocuted and die. If you are willing to learn how to do the wiring in My Summer Car then read this simple guide where we have explained everything step by step.

How To Do The Wiring Step By Step In My Summer Car?

Wiring can be a pretty messy task if you do not know where to start and end. Additionally, wiring is only possible when you have completely built the car into a working state. This is the final stage of the car where you can run electric supplies to turn ON the necessary indicators and light.

Wiring

Before you start wiring, make sure you follow these necessary steps:

1. Unscrew the Starter bolts and the Terminals of the Battery. (Unscrew the Negative Terminal then Positive Terminal)
2. Remove the Headlights and Grille.
3. Do not connect the Battery.

Engine

Locate the Main Harness Connector i.e. on the back side of the body under the right wiper.

1. Connect the Ignition Coil to the Main Harness Connector.
2. Connect the Radiator Fan Connector to the Main Harness Connector.
3. Connect the Regulator to the Main Harness Connector.
4. Connect the Regulator to the Alternator.
5. Connect the Positive Terminal of the Battery to the Main Harness Connector.
6. Connect the Positive Terminal to the Starter.
7. Connect the Negative Terminal to the Battery Ground Connector.

Exterior (Front Side)

Spot the Front Lights Connector which will be found on the right side slightly to the headlight.

1. Connect the Wiring Mess from the Headlight Right to the Front Lights Connector.
2. Connect the Wiring Mess from the Headlight Left to the Front Lights Connector.
3. Connect the Main Harness Connector i.e. located in the back body under the hood to the Front Lights Connector.

Exterior (Back Side)

Open the Boot and spot the Rear Harness Connector which will be on the right side of the trunk.

1. Connect the Rearlight Left to the Rear Harness Connector.
2. Connect the Rearlight Right to the Rear Harness Connector.
3. Connect the Fuel Tank to the Rear Harness Connector.

Interior

Locate the Fusebox on the front right side of the hood behind the glove box.

1. Connect the Ignition Switch to the Fusebox.
2. Connect Instrumental Panel 1 to the Fusebox.
3. Connect Instrumental Panel 2 to the Fusebox.

Locate the Radio Harness under the right wiper in the Dashboard.

1. Connect the Radio to the Radio Harness.

Locate the Dash Harness Connector behind the Clock Gauge.

1. Connect the Light Switch to the Dash Harness Connector.
2. Connect the AFR Gauge to the Dash Harness Connector.

Screw The Loose Ends

Remember we had unscrewed the Starter and the Positive Terminal of the Battery. We will require to screw it back on once the Wiring is connected throughout the whole car.

First screw both the bolts on the Starter. Next, make sure you first screw the Positive Terminal of the Battery and then finally the Negative Terminal of the Battery. Why? Because if you screw the Negative Terminal first, the car will catch fire.

Now you have the working car!

• How To Brew The Strongest Alcohol – Kilju?