Car Mechanic Simulator 2021- Second Car Griffin Tyro (2015) Guide

Car Mechanic Simulator 2021At Car Mechanic Simulator 2021, the second car as per the story would be the green-colored standard Griffin Tyro (2015). As soon as you assign the car to Car Lift A, the Car Status will confuse almost everyone as the Part Not Discovered is something which we were not yet prepared for. The owner has not yet discovered which part to report and as being the Mechanic we are supposed to know it all or learn it all. In this guide, we have compiled all the parts locations where you need to focus and fix the issue.

Second Car Griffin Tyro (2015) Guide In Car Mechanic Simulator 2021

Car Mechanic Simulator 2021

The parts that need to be focused on are shown in the image above. All major works are at the Engine section, so we focus on Brush Pads, Brake Disc Ventilated, and Rubber Bushing.

  • Lift the car
  • Remove Tire
  • Remove Brake Caliper
  • Remove Brake Pads x4
  • Remove Brake Disc Ventilated x2
  • Remove Oil Filter(14) (Engine)

Car Mechanic Simulator 2021

For Rubber Bushing, it will be connected with the Rear Suspension Arm as shown in the image above. Similarly, the second Rubber Bushing will also be located at the rear end. The rest of the 2 Rubber Bushing will be placed near from tires at the Front Suspension Crossmember as shown in the image below.

Rubber Bushing

For Engine Section, make sure that you have drained all the fluids. Now to gain access to the parts, you will need to follow the steps after selecting the Engines Left part:

Car Mechanic Simulator 2021

  • Remove Idle Roller A
  • Remove Serpentine Belt (14B)
  • Remove Crankshaft Pulley (14)
  • Remove Timing Cover A (14B)
  • Remove Belt Tensioner
  • Remove Idle Roller A x2
  • Remove Serpentine Belt A (14B)
  • Remove Cam Gear (14 SHC)

Remove Timing Cover B (14B) from another side which will be connected with Camshaft. After removing all the parts from the Timing Cover B to Cam Gear B (14B). Once the Camshaft will be free follow the process:

  • Remove Ignition Coil x4
  • Remove Engine Head Cover (14B)
  • Remove Spark Plug x2
  • Remove Camshaft Cap (14B) x4
  • Remove Camshaft (14B)

Do not forget to mount all the parts and refill all the fluids in order to complete the job. For more guides on Car Mechanic Simulator 2021, click the following link that has been mentioned below the description:

Leave a Reply

Your email address will not be published. Required fields are marked *